Swapping Your Watch Strap for a Bracelet: Width and Compatibility Tips

Nowadays, watches are also made of many materials, the most common being stainless steel and genuine leather. The tape or adhesive tape has a period of use, and when replacing it, it should be noted that the width of the strap should be compatible with the width of the opening of the casing, and should not be too narrow. When the strap is narrow, it will run left and right, and it is easy to press the spring of the strap bolt and drop it, causing the watch to malfunction, and it is not beautiful at the same time. (Especially the kind with longer strap bolts and larger diameters). Ordinary belt width: male 18MM, female 10MM,12MM. the thickness of the strip should also take into account the gap between the opening point and the strap bolts, if too thick will be stuck between the strap bolts and the strap, so that there can not be ambidextrous.

Precautions when changing meters:

1. The belt loop (short section) of the belt loop (short section) is always on top of the watch (when the watch is looking straight ahead, the bracelet is on the right). Unlike artificial belts, the direction of installation is regulated.

2. Metal strap. When the watch is spread out, the letters or logos on the strap discount should be consistent with the dial, if it is upside down, then the strap is installed backwards. You can use your thumb to open the clasp on the right, butterfly clasp can only see whether the logo and dial is a smooth. The strap is reversed, opening and closing must not be smooth.

3. Other relevant issues:

The strap has a folded edge and many holes on the side for adjusting the length of the strap. It is also important to pay attention to the buckle adjustment knuckle (retraction and release) when retracting the strap which is not retracted with the strap closed. This buckle creates leverage, making it very easy to open and also easy to lose the watch.

When unloading metal straps with knuckles, it is best to have a double row, and both the left and right sides of the clasp should be unloaded evenly. So, make sure that the clasp is centered for comfortable wear, especially for ladies with thin wrists, and pay attention to this when removing the strap knuckle.

Usually there is an arrow on the band section to indicate the direction in which the peg is to be punched out, not reversed, and installed in the opposite direction of the direction it was taken. The bolting of an empty core strap section to a section is generally referred to as a "hairpin". Easier to loose and tampering, while the solid core belt generally use through the nail or screw connection, after a period of time, may also be loose tampering, so be sure to check regularly. Use a needle to push the needle outward with force, assuming that, as soon as you push the pegs will pull out, i.e., loose. If you notice any obvious signs, fix it immediately. Some watches especially like to appear this situation, own buy RADO, also worth more than ten thousand it. Once fell to the ground they do not know, fortunately saw me reminded me, did not cause damage, and later found that it was a wear nail on the strap fell. A lot of tables lost for this reason, it is recommended that we change the table every 7 to 8 years, this kind of thing is very cheap. When using screws it's best to touch the glue when pressing to make sure it's secure.

A watch band that looks like a holster is easily damaged and will need to be replaced with a new one after a few years. When replacing a watch band, you should pay attention to the size of the band, but also consider the color, especially for fashionable watches. If you want to know more about watch straps, you may want to pay attention to theWatchdog websiteTake a look.